Input
Type active electronic, balanced or unbalanced
Impedance 1M Ω nominal, balanced or unbalanced (jack connectors) 20K Ω (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Maxmum level 30dBu
Attenuator 30dB switchable

Output
Type Transformer Isolated, balanced
Impedance 300 Ω
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ω
Min. load 600 Ω

Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu

Power Requirement
Voltage +48V Phantom *
Current consumption <10mA

Weight <1kg

Dimensions
Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)

* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.

Trade Descriptions Act:
Due to the company policy of continuing improvement, we reserve the right to alter these specifications without prior notice. E&OE.

Back to DN100 DI Module